Premio Computer Premio Apollo/Shadowhawk Computer Manual de usuario Pagina 29
- Pagina / 122
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
CHAPTER 2 HARDWARE INSTALLATION
2-3
• Fan Power Connectors: CPUFAN/PSFAN/SYSFAN
These connectors support system cooling fan with + 12V. It sup-
ports three pin head connector. When connecting the wire to the
connector, always take note that the red wire is the positive and
should be connected to the +12V, the black wire is Ground and
should be connected to GND. If your mainboard has System Hard-
ware Monitor chipset on-board, you must use a specially designed
fan with speed sensor to take advantage of this function.
For fans with fan speed sensor, every rotation of the fan will send out 2
pulses. System Hardware Monitor will count and report the fan rotation
speed.
Note: Always consult vendor for proper CPU cooling fan.
PSFAN
CPUFAN: Processor Fan
PSFAN: Power Supply Fan
SYSFAN: System Fan
CPUFAN
+12V
SENSOR
GND
+12V
GND
Sensor
SYSFAN
+12V
GND
Sensor
- Apollo/Shadowhawk 1
- System Manual 2
- Copyright 3
- Disclaimers 3
- Contents 4
- Getting Started 6
- Setting Up 7
- Switches and Indicators 8
- 4 Premio System Manual 9
- Upgrading 10
- Opening the System Unit 11
- Installing an Expansion Card 12
- Installing a Hard Drive 13
- Getting Help 14
- Keyboard Does Not Work 15
- Mouse Does Not Work 15
- System Unit Problems 16
- Hard Drive Problems 16
- Technical Support 17
- Premio on the Internet 17
- Appendix 18
- Service Under Warranty 19
- FCC Standards 20
- 16 Premio System Manual 21
- Appendix 17 22
- Chapter 1 23
- INTRODUCTION 23
- Mainboard Features 24
- Mainboard Layout 26
- MS-6339 ATX TH1 Mainboard 26
- Chapter 2 27
- HARDWARE INSTALLATION 27
- Central Processing Unit: CPU 27
- CPUFAN: Processor Fan 29
- PSFAN: Power Supply Fan 29
- SYSFAN: System Fan 29
- Clear CMOS Jumper: JBAT1 30
- • Memory Bank Configuration 31
- RIMM1(Bank0+ Bank1) 31
- RIMM2(Bank2+ Bank3) 31
- RIMM3(Bank4+ Bank5) 31
- RIMM4(Bank5+ Bank4) 31
- • Memory Population Rules 33
- Case Connector: JFP1 34
- Floppy Disk Connector: FDD 36
- Primary IDE Connector 37
- Secondary IDE Connector 37
- Power Supply 38
- PIN DEFINITION TABLE 40
- 1 2 3 4 5 43
- 6 7 8 9 43
- Parallel Port Connector: LPT1 44
- Mouse Connector: JKBMS1 45
- Keyboard Connector: JKBMS1 45
- Line Out 46
- USB Connectors 47
- 1-3 Blink 50
- CD-In Connector: J8 52
- AUX Line In Connector: J9 53
- Modem-In: J10 54
- Onboard Audio Codec: JP1 55
- Clear BIOS Password: J18 57
- BIOS Flash Jumper: J17 58
- Audio speaker 59
- USB Front Connector: JUSB1 60
- BIOS USER’S GUIDE 62
- Chapter 3 62
- Enter BIOS Setup 63
- Standard CMOS Setup 65
- BIOS Features Setup 66
- Quick Boot 67
- Try other Boot Devices 67
- Boot up Num Lock 67
- Floppy Drive Swap 67
- Chipset Features Setup 69
- CPU Frequency Ratio 70
- USB Function 70
- Memory Hole 70
- Graphics Aperture Size 70
- IPCA Function 73
- Sleep State 73
- Sleep State LED 73
- Wake Up On PME 75
- Resume By Alarm 75
- PNP/PCI Configuration 76
- Clear ESCD 77
- PCI VGA Palette Snoop 77
- DMA Channel 0/1/3/5/6/7 77
- Integrated Peripherals s 79
- Floppy Controller 80
- Serial Port A/Serial Port B 80
- Serial Port B Mode 81
- IR Duplex Mode 81
- IR Pin Select 81
- Onboard CIR Port 81
- CIR IRQ Select 81
- Port Mode 82
- EPP Version 82
- Onboard Parallel Port 82
- Onboard parallel port set at 83
- Parallel Port IRQ 83
- Hardware Monitor Setup 84
- Chassis Intrusion 85
- Supervisor/User Password 86
- IDE HDD Auto Detection 87
- Chapter 4 88
- BIOS SETUP 88
- Main Menu 89
- Advanced BIOS Features 90
- Boot Up NumLock Status 97
- Gate A20 Option 97
- Typematic Rate Setting 97
- Typematic Rate (Chars/Sec) 97
- Typematic Delay (Msec) 97
- Security Option 98
- HDD S.M.A.R.T Capability 98
- Report No FDD For Win 95 98
- Advanced Chipset Features 99
- AGP Aperture Size (MB) 101
- Integrated Peripherals 102
- USB Controller 103
- USB Keyboard Support 103
- Init Display First 103
- Midi Port IRQ 106
- Power Status LED 106
- Onboard Parallel Mode 106
- PWRON After PWR-FAIL 106
- Power Management Setup 107
- ACPI Suspend Type 108
- Power Management 108
- Video Off Method 108
- Video Off In Suspend 109
- Suspend Type 109
- Modem Use IRQ 109
- Soft-Off by PWR-BTTN 109
- Wake-Up by PCI Card 109
- Power On by Ring 110
- Wake-Up on LAN 110
- CPU Thermal-Throttling 110
- Resume by Alarm 110
- Reload Global Timer Events 111
- PnP/PCI Configuration Setup 112
- Reset Configuration Data 113
- Resource Controlled By 113
- IRQ Resources 113
- PCI/VGA Palette Snoop 113
- PC Health Status 114
- CPU Warning Temperature 115
- Shutdown Temperature 115
- Frequency/Voltage Control 116
- Set Supervisor/User Password 118
- Features 120
- System Requirements 120
- Audio Driver Setup 121
© 2020, manymanuals.es. Todos los derechos reservados | 0.037 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales